Adjustable Trade Lock Jig Instructions

To use the B W Lockjig you will need:

• A plunge router
• 12mm long reach cutter
• 16mm guide bush and a 4mm spacer
  Or
• 17mm guide bush and a 5mm spacer
• A wedge or some type of door clamping device to hold the door in place while using the B W Lockjig.
• Hand Tools

INTENDED USE
This adjustable trade lock jig is intended to be used with a plunge router with a suitable guide bush and router cutter selected and fitted to rout the spindle hole, the selected keyhole type aperture and the faceplate. The B W Lockjig is placed on the door at the given spindle height and then tightened. A self centring drill bit guide with a sleeve width of 6mm can be used to mark for the bolt through holes. (Warning, using a regular drill bit will over time increase the bolt through hole size and damage the side plates.)

SAFETY
Please take the time to read and understand the B W Lockjig safety instructions, and the power tool instructions, before use.

• Keep these instructions in a safe place.
• Users in the UK must pay attention to the Provision and Use of Work Equipment Regulations 1998, and any subsequent amendments.
• The user should also read the HSE/HSC Safe Use of Woodworking Machinery Approved Code of Practice and Guidance Document and any amendments.
• The user of this product must be competent in using wood working tools and equipment.
• All users must be competent in using woodworking tools before using this product.
• The user must consider the working environment before working with tools.
• Make sure the door is held in place securely with a wedge or a clamping device, and that the working area is clear of obstructions. Also make sure that the user is in a comfortable position before use.
• Please keep children/visitors clear from tools and the working area. Power tools come with a certain amount of risk so the operator must proceed with caution.

Tools used must meet EN847-1/2 safety standard and any amendments.